Hardwood Flooring Maintenance and Refining

Wooden floors require regular maintenance to extend their lifetime. There are various ways one can go about this, however it is best to be thoroughly informed before cleaning hardwood. This way you can avoid the quite a few mistakes and pitfalls people sometimes make that can definitely damage your floors and reduce their lifetime.

In this article understand how identify the finish of your floors, and using this information you could decide between several ways of cleaning, refinishing or putting wax on your floors. Each cleaning technique is outlined with clear information that should be followed as closely as possible in order to properly maintain the floors.

To begin, you must first define the finish of your floors. In the event you installed the floors yourself, either you or your contractor are fully aware exactly what finish they are. If you do not know, read on.

Identifying the finale

Most hardwood floors come in one of 2 finishes: prefinished and unfinished hardwood. To learn more about these 2 types of is done, read the article on Prefinished vs . Unfinished Floors.

Prefinished Hardwood Floors are most commonly sealed at the surface to protect filth and moisture from entering in and causing deterioration. To clean these floors, you cannot use any sort of oil as well as wax-based products or cleaners.

Prefinished floors are water-resistant and the best way to care for them is to sweep and hoover often , or use a water-and-soap solution to clean. A simple alternative can be made using the following:

1 . ΒΌ Cup connected with dishwashing soap
2 . A Bucket full of water.

Easily mix them together in the bucket and use a mop to clean the floor. WARNING: Do not use a fully wet cleaner, make sure to wire out the water-and-soap solution just enough so the clean is damp, rather than wet.

Many people believe that rather than water-and-soap, a water-and-vinegar solution works better. This may seem true, even so using vinegar comes with the risk of causing damage to the floor’s finish because of vinegar’s acidic nature. The best recommendation is with a water-and-soap solution.

To clean scuff marks on prefab hardwood floors, rub a bit of baking soda on to a humid sponge and buff the scratches away. To clean food spills and grease, ALWAYS use a commercial cleaner.

Unfinished hardwood flooring toronto surfaces require much more care when cleaning and maintaining these individuals. Unfinished floors are finished and seal-treated onsite over the installation. They are also much more prone to moisture damage and so you’ll want to avoid water-based cleaning when dealing with them.

Over time, incomplete hardwood will see a lot of wax buildup which can both possibly be damaging to the floor and make it look very dreary. To clean and restore the floor’s original shine, start using a stripper to remove old wax buildup. Always make sure to ask often the hardwood’s manufacturer to recommend a commercial product that can accomplish this.

 

About the author: admin

 

 

Recent posts in flooring

 

No Comments

Comments are closed.